Planning on finishing an ercf this year and going can for that so figured good opportunity to swap the hotend over, saved a substantial amount of wiring even compared to the hotend PCB I had, saved the wiring harness just to compare went for a usb can device over running can from the octopus pro, did want to swap the pro over to can as well but ended up keeping it the same instead of messing with reflashing firmware. Hotend has a little 3015 fan and a heatsink on the arm chip so cooling should be fine, looked up the datasheet and it's got a tjmax of like 120c and rated for ambient -40-80c so don't think I need to worry about it, if it's an issue I'll run a fresh air feed to it, will see how it likes abs in the summer shortly.
All in all, super easy swap over, definitely cleaned up my rats nest (though I still should cut the stepper wires to length, they hide in the imitation panduit I printed, it's neat enough to be serviceable and not be a hazard), used katapult (formerly canboot) and then flashed klipper onto the board, only minor issue is it uses these tiny jst connectors, like really small, btt ebb sb2209 and btt u2c usb can device, was a good resource to follow for any of the network interface configs that I needed to do and gave some good details on diagnostics.
Quick question to the community, does anyone have some good tools to sculpt stls or step files?
Context, I'm working on some decorative keychains and have a vector image and text I want to add to the base object. I've used aolidworks for both in the past with alright results but I've switched over to freecad this year, haven't had a lot of luck adding in there, vector image is a tracing of a dog that I was provided, it's simplified but still has a lot of components.
I did look into blender but be honest I'm totally lost using it and have no clue what I'm doing coming from parametric modeling, I'm not an artist at all, my comfort zone is functional parts usually, but was approached by a friend. I did do some mockups in prusa/superslicer where I've added my image and text as negative volumes and merged into a single part. It works but it feels like a really hacky workaround (relevant XKCD) and would prefer to do it right. Any suggestions or resources would be appreciated!
If interested, here's the mockup that I've done a few test prints on, found I needed to change the line width of my vector a few times and made some features exaggerated so they'd come out more. I've (poorly) covered some identifying text on the back, left the rest as to get a feel for what I'm trying to do, did do some rough sanding on the below pictures. There's a pocket on the top edge that accepts a keyring, it's kinda chunky, about the size of a pog slammer or a thicker poker chip.
Just as an FYI because it's saved me grief in the past, both klipper and octoprint can be setup to exclude certain objects while printing. You need to setup your slicer to provide gcode that enables the feature, but it allows you to stop printing a bad object, can reduce wastage in the case where only one part has failed but the others are ok.
Prusa/Superslicer are what I have experience using it with, I used a preprocessing script to output compatable gcode but apparently there's a label objects option directly in both slicers, the klipper link below goes over enabling that feature.
@morbidcactus
@lemmy.ca