When I ask about my gender on StackExchange, people tell me to just use Arch, but I don't think I'm fully a trans woman?
Thanks, and good luck! In Orca, I set it to all walls fuzzy, 0.5mm between points, and 0.2mm depth, and I like the results.
Thanks for showing us this! I printed one with “fuzzy skin” and it is so cool (unfortunately doesn’t show up well in photos though).
SV06 Plus, SV07, and SV07 Plus all use the same nozzles. However, I think standard volcano nozzles would also work – I just haven't bothered to try since I bought a five-pack of the proprietary nozzles off AliExpress and they work perfectly fine.
Yes, adaptive cubic varies the density of the cubic structure to decrease filament usage while supposedly maintaining the same strength as normal cubic. And, in my own experience, gyroid always takes longer to print than adaptive cubic – sometimes it only adds a few minutes, but I’ve seen it add nearly half of the print time again for infill-heavy prints.
I just wish it didn’t take so much longer to print than adaptive cubic at the same infill percent.
The hint in this case is "God bless you"
That's actually the abuse showing through. It's intentional passive aggression and a manipulative speech pattern. It's meant to imply, "God bless you, even though you're breaking his rules and making him sad and probably going to hell".
And before you ask, I was raised evangelical, was deeply involved in ministry, went to bible school, and even worked at a church for a few years; I know how these people think because I was one until I saw the light and ditched their religion. The number of times I've seen "I'll pray for you/them", "God bless you/them", and such used as insults is too damn high.
@lapis
@lemmy.blahaj.zone